1.Loosen the handle’s screw nut, but do not take it down, rotate the plate pinch180 degrees.
2.Take the upper cover out with magnet, the top of oil in the cylinder return to lowest position, put half oil seeds then put the thin iron plate before filling another half oil-seeds.
3.Cover it and move the upper platen back into original position.
4.Turn on the power of heat ring, preheat the pressing cage.
5.Open the switch of electric pump, start to squeezing. About 10mins.
6.After pressing, relieve the cylinder pressure. Loosen the screw nuts,rotate the upper plate pinch180 degrees. Take out the cover plate with magnet.
7.Tighten the screw nuts, eject the cake out.
8.Return the hydro-cylinder and rod to lowest position.
