1. Fill hydraulic oil up, then connect the power.
2. Rises the oil cylinder rod about 5 cm.
3. Put it into oil pan.
4. Put the top plate, top plate is 3 cm thick, the M10 screw plus copper pads (copper pads to prevent oil spills) fixed on the oil rod.
5. Put the hydraulic oil tank in the bottom support.
6. Fix the electric heating ring and connect the wire.
7. 60Mpa。Gauge pressure must not exceed 60Mpa.
8. Open and close switch timely result from the electric pump’s pressure go up very fast after connect with electricity.
